Anadex Labs Pty Ltd    
  Anadex Labs
  Easy water tank level display and control
 
     
       
 
         

 

Installing the T434B water level transmitter
  Suitable for installation in all types of non pressurized water and rainwater tanks including concrete water tanks and underground water tanks
 		  
    Step 1
 Drill 5 holes using the drill template that has been supplied. 		  Holes drilled on top of thw rainwater tank

 
    Step 2
 Feed the depth sensor cable from inside the water tank through the cover plate and screw down the cover plate. If you intend to install the sensor at a location where you cannot reach to feed the cable from inside, you will have to drill a 22mm hole into the tank, so that the sensor can be dropped down into the tank. Feed the sensor cable through the cover plate and screw the plate down.		   Depth sensor cover plate in place.  
    Step 3
Pull the depth sensor cable through the cover plate so that it is positioned at the same level as the water tank outlet.		   View of the depth sensor installed in the rainwater tank.  
    Step 4
 Connect the depth sensor wires to the Tank Unit, and screw the Tank Unit down onto the tank (2 screws).

 

   Depth sensor cable connected.  
    Step 5
Insert the battery or optionally connect a external 12 to 24V DC power source. 		  6V Lantern battery installed in the T434B Tank Unit.  
    Step 6
Set the Water Depth, Alarm levels and Sample Rate on the dials.		   Setting the dials on the T434B Tank Unit.  
    Step 7
Test communications with the Command Module by using the Communications Test switch. Put the cover on. - AQUAMETA is now ready to start transmitting your water tank level to you.

 

   T434B installed on top of a rainwater tank.  
 
  22/11/06     Copyright Anadex Labs Pty Ltd 2006